2 Vinyl Sheets Chevy Bowtie Emblem Overlay Grill DIY Cut Wrap Cover Matte Black

Description

Description
You will receive TWO (2) VINYL SHEETs that are Approximately 11" X 4" inch to apply over the factory OEM emblem.Each sheet is designed to be applied over the top of your factory emblem exactly as shown in the picture. If you have questions about what you are buying, ask before ordering.
This will fit the Grille, Trunk/Hatch/Tailgate of virtually any Chevy vehicle emblem/ Front and Rear emblems, as long as the measurements of your emblem are smaller than the sheet size (11"x4" inch)
This is NOT a pre-cut kit. Includes emblem wrap sheets. This is not a replacement bowtie. No need to modify or replace your bowtie emblem.
Includes
(2) 11" x 4" inch vinyl sheets to cover (2) emblems (Not Pre-cut)
Features
Allows you to obtain a custom appearance to your Chevy emblem without permanently changing it.
Easier to install than a pre-cut decal as this allows more room for error. Apply the vinyl sheet and trim away the excess.
Our emblem wrap material has been tested to specifically work on the sharp contours of emblems
Our emblem wrap material is rated for 3-7 years of outdoor use. (depending on environmental conditions)
Protects emblems from scratches and normal wear and tear
The vinyl outdoor durability is rated for 5-6 years. It will not crack, peel, or fade.
Will not harm your natural finish or paint. Waterproof and stain resistant
DIY Application Instructions / How to Install
Wash Your Hands before handling the vinyl. Clean vehicle surface thoroughly with soap and water or cleaner/degreaser, then again with rubbing alcohol to remove all wax.
Align the decal sheet over the emblem. Note* Make sure to install Install decal when temperature is above 50 degrees. Or you may use an air dryer to ensure adhesion.
Ensure surface is dry. Slowly and carefully apply decal to vehicle surface. Do not rush or you may risk damaging the sheet.
Starting from the center, apply pressure across the sheet to remove air bubbles. If any air bubbles persists, they can be removed with a needle as a last resort ONLY if they cannot be removed with firm pressure.
Cut off the excess around the edges with an razor blade/exacto knife.
Shipping
All orders are shipped with a Tracking Number. You can expect your item to arrive 3-10 business days from the time you order. If you are concerned about your item please do not hesitate to contact us through eBay’s messaging system. If your item arrives later than expected or if it arrives damaged, please give us the opportunity to resolve any problems. We will work hard to resolve any issues as fast as we can. If there is damage please send a picture prior to applying. We cant replace the decal due to installation issues. Please Follow the DIY Application Instructions / How to Install (Above)
There are no refunds for installed products. We are not responsible for any bubbling, repositioning, or adhesive issues due to incorrect or improper installation.