2023 - 2024 Fisker Ocean Pre-Cut UV Door Handle Protection Matte Film PPF

Description

Everyday use can leave your door covered with scratches and scuffs Don't let your door handles disintegrate!
Save yourself the pain of that sight and keep them looking new with this PPF Kit.
Easy DIY peel & apply application (see below)
Tools & instructions included
Lasts 10 years
Designed and made in the USA
Includes:
PPF for Door Handle Area
Squeegee
Install Guide
Specs:
Made out of VVIVID XPO UV RESISTANT PPF MATTE
Fits 2022-2023 Fisker Oceans
FAQs
Can I install PPF over ceramic coating?
Unfortunately, PPF will not adhere to ceramic coating. We do not recommend installing if you already have a ceramic coat.
How long should I wait to drive my Ocean after installing PPF?
We highly recommend waiting at
least 24 hours before driving. This ensures your PPF has had time to
adhere fully so water and debris can’t get under the surface.
What temperature should I install PPF?
PPF is best installed in
temperatures between 65 and 75 degrees F. If it’s too cold, it may feel
stiffer. If it’s too hot, it’ll stretch more.
How do I remove wrinkles (also called fingers) when installing?
If it’s a small finger, the
easiest way to push it down is to use some water and alcohol, 15% alcohol and 85% water in a spray bottle and then push
it down with your squeegee. If it persists, wrap your squeegee with
microfiber and squeegee it down. The microfiber will absorb the water,
making it tackier.
Is it okay to leave small bubbles when installing?
If it is larger than a nickel, you
want to lift the PPF and squeegee it down again. If it’s smaller than a
nickel, it should dissipate and evaporate within time.
How long should I wait before cleaning my Ocean after installing it?
We recommend waiting at least 24 hours but 48 hours to be safe.
What will i need to install?
Microfiber rag, spray bottle with 85% water and 15% rubbing alcohol in a spray bottle.
*Squeegee will be provided
Do I need to cut anything?
No, our kits come pre-cut to make installation easier for you!
Can I use a pressure washer to wash my car after installing the ppf?
You can, but please be extremely
careful. You want to be careful around all the edges. If you directly
point the spray gun near the edge, it may remove the film. Don’t
directly spray on the edges, and you’ll be fine.
Why does it only come with 1 set?
PPF is easier to adjust since it
is a wet install compared to vinyl which is a dry install. If you do
make a mistake, reach out to us, and we can send you a replacement at
cost.
How long does PPF last?
Our film is rated for 10 years.
Can I put a ceramic coating over PPF?
Absolutely. There are many ceramic coatings that are specifically for PPF which will make the car even easier to keep clean!
Instructions
Recommend cleaning handle area with 70% isopropryl alcohol.
Spray your hands with some water and mild soap such as dawn
Spray the PPF Film Front side and Back side with some water and soap so the film is easily positioned
While film is wet on both sides apply to handle. Film will not wrap around the handle.
Carefully squeegee your door handle cover.
Once handle is properly aligned fill a small spray bottle with a solution of isopropryl alcohol and water.
Lift the corner edge and spray the water and alcohol mix then lightly squeegee the solution across the handle, this well help cure the handle cover.
Spray the alcohol solution over the handle cover (on top of film) and lightly squeegee the film down
The instructions above wont damage your led strip and will protect your led cover from disintegrating with the UV protection film.