G125 GO-NO-GO - Go-No-Go Gauge For AF8/AFM8 Crimpers

Description

This Go-No-Go Gauge is designed for use with the AF8 and AFM8 Crimp Tools from DMC. Over time and repeated use a crimp tool can eventually lose its accuracy or get damaged and have its tolerance changed. Usually the changes are minimal and acceptable, but sometimes the slight change in calibration can be outside or acceptable tolerances. To ensure your tool still fits the standard used by other wire crimpers and cable installers, test it with this Go-No-Go Tool. Just insert the GO end and make sure it fits, and then insert the No-Go and make sure it does not fit. This double test will ensure that your crimper is higher than the minimum tolerance and lower than the maximum tolerance, making sure that all connectors and wires crimped with the tool will fit other connectors and wires in any assembly.
Features:
Easy design provides quick results.
Tests for a standardized and accurate crimp.
Two testing ends to ensure proper tolerances.
Strong and durable design.
Specifications:
M22520/3-1
Green GO end of .0390
Red NO GO end of .0440
For use with
AF8
and
AFM8
Crimp Tools
3.50 inches long
Weighs 2.08 OZ