-40%

Threaded Adapter to Connect Two Dremel Flex Shafts Together to Double the Length

$ 14.78

Availability: 100 in stock

Description

The following item (threaded adapter to multiply the length of the Dremel Flex Shaft) was developed to extend the usefulness of the
Dremel Flex Shaft attachment.
Extends life of flex shaft by reducing the bend radius of cable.
The internally and externally threaded adapter connects two Flex Shafts together to double or triple the working length of the tool.
The machined flat areas on the 3/4 externally threaded diameter are for tightening the threaded adapter, with a 5/8 open end wrench,
to the 1/2-20 male thread under the internally threaded cap of the Flex shaft Handpiece. The cap will not be used in this assembly.
Complete the
connection
of the second Flex Shaft as you connected the first Flex Shaft to the power tool.
The two notches on both sides of the threaded adapter are intended to help remove the adapter if it gets stuck in the housing nut
due to improper installation.
A penny works as the wrench.
Buyer must purchase the second Flex Shaft at a place of your choosing.
Cost Approx. .00