Trigger resistance springs for CZ 455 / ZKM 452

Description

A set of springs used to reduce the resistance of the
CZ 455 trigger from the factory 1.3 kg to 0.3 kg
, according to your preferences. The strength of the trigger resistance is affected by more factors than just the force of the springs. Therefore, take the achievable resistance as a guide, it can vary by a few percent.
The adjusting nuts on the spring guide are used to fine-tune the resistance.
ATTENTION !!!
When the trigger resistance is set below 1 kg, firing occurs when the weapon falls. This is due to the construction of the trigger mechanism, where the point of rotation of the trigger is not in the center of gravity and the firing occurs by the movement of the trigger by the inertia of the mass.
When the lowest trigger resistance is set, firing may occur when the weapon is unlocked! This fact must be kept in mind! For the above reasons, we do not recommend setting low resistances for hunting weapons and for sporting weapons it is necessary to keep these parameters in mind!
The set contains all the necessary components and its assembly can be done by an average skilled handyman. If you do not dare to assemble it, entrust it to your rifleman.
Overview of spring resistances (kg)
0,34 - 0,45
0,45 - 0,57
0,68 - 0,80
0,90 - 1,13
original 1,2 - 1,4
Package contains
1pc Set of springs to gradually reduce the resistance of the CZ 455 trigger up to 0.3 kg
Tactical EVO offer, a great choice for your work and hobby.